Pattern Selection Mode - Brother BAS-705 Instruction Manual

3-2-6-1. Pattern selection mode

* The following procedure lets you select the stitch pattern.
There are three different basic patterns which can be selected, and these patterns are pre-programmed
into the sewing machine's ROM.
X-Y/PROGRAM/(ADJ)
Program No.
Xscale(%)
Yscale(%)
* The enlargement and reduction settings can be applied to each of the patterns as described below.
Program No.11/21/31
Program No.12/22/32
Program No.13/23/33
NOTE:
If the ENTER switch is pressed while any patterns other than the above are selected,setting
will not be possible.
SELECT
e
[Operation method]
MM
* Use the
Set based on program No. 1
Set based on program No. 2
Set based on program No. 3
[Input method]
CANCEL
r
ENTER
t
19
SELECT switches e to change
and
the numbers, and use the and
e to move the cursor "-" .
* The patterns that can be set are the patterns with
numbers from 1 to 3.
1. Press the ENTER switch t to select the second
line of the display.
SELECT switches e to change
2. Use the and
the numbers, and use the
switches e to move the cursor "-" .
3. If the CANCEL switch r is pressed while the
cursor "-" is displayed, the display will return to
the item selection display without the setting being
changed.
4. If the ENTER switch t is pressed while the cursor
is displayed, the setting value will be changed to
the value displayed and the display will return to
the item selection display.
3. PANEL OPERATION
SELECT switches
and SELECT
BAS-705