Dip Switch; Panel Dip Switch Functions - Brother BAS-705 Instruction Manual

8. DIP SWITCH

8. DIP SWITCH
NOTE When changing a DIP switch, the power must be off.
The power must be off when changing the position of a DIP switch.
After the position of a DIP switch has been changed, the altered function will not take effect until
the power is turned off and then turned back on again.

8-1.Panel DIP switch functions

SW1-1 To activate the thread breakage detector
SW1-2 To V-cut a belt loop
SW1-3 To display Japanese
The fork is retracted when the FOOT
SW1-4
switch or BOBBIN switch is pressed.
SW1-5 To activate loop set sensor
SW1-6 Loops are fed at low speed.
To activate folding switch
SW1-7
After automatic sewing, the presser foot
SW1-8
remains down. Pressing the RESET
switch will raise the presser foot.
ON
68
No 1
No 2
OFF
To deactivate the thread breakage detector
To flat cut a belt loop
To display English
The fork is not retracted when the FOOT
switch or BOBBIN switch is pressed.
To deactivate loop set sensor
Loops are fed at normal speed.
To deactivate folding switch
After automatic sewing, the presser foot
rises.
BAS-705