Level 2 Ike Configuration Commands - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands
Example

Level 2 IKE configuration commands

action command (configure IKE level)
WG#config<ENTER>
WG(config)#ike <ENTER>
WG(config-ike)#action <"name"> \
<-main_mode|-aggressive_mode> [no]
[-natt <enable|disable> [-natt_keepalive
<seconds>] ]
[extended_authentication] [+] \
-rsa
{<g1|g2><des|3des><md5|sha><lifetime<min|h
r> \
&|lifesize<KB|MB>>} \
-dss {<g1|g2><des|3des><md5|sha><lifetime
[min|hr]&|lifesize [KB|MB]>} \
-preshared
{<g1|g2><des|3des><md5|sha><lifetime \
[min|hr]|lifesize \ [KB|MB]}
Effect
78
to the HA1 ports, an added level of redundancy is
insured.
primary <ha1|ha2> ip </prefix|mask>
secondary <ha1 ip>| <ha2 ip </
prefix|mask>>
This allows you to set the IP addresses and
netmasks for the primary and secondary device's
HA ports.
WG#config<ENTER>
WG(config)#high_availability <ENTER>
WG(config-ha)#advanced
WG(config-ha-advanced)#primary ha1 ip \
10.10.10.11|255.255.0.0 \
secondary ha1 ip 10.10.10.12
Records a new IKE action, for use in IKE policies.
WatchGuard Vclass 5.1