Level 2 Tenant Configuration Commands - Watchguard V10 Command Line Interface Manual

Example

Level 2 tenant configuration commands

vlan command (configure tenant level)
WG#config
WG(config)#tenant
WG(config-tenant)#vlan
<"name"> <-id num> [-interface <0|2|3>]
assigned for
Effect
WatchGuard Command Line Interface Guide
Second level configuration mode commands
WG#config<ENTER>
WG(config)#license<ENTER>
WG(config-license)#show
OrdLicense NameLicense IDExpiration
Date
1V80_3DES_HA_Bundle3293MXLD17-05-2022
or
WG#config<ENTER>
WG(config)#license<ENTER>
WG(config-license)#show 3293MXLD
License Name:V80_3DES_HA_Bundle
License ID:3293MXLD
Feature(s):HA
3DES
UPGRADE
Expiration Date:17-05-2022
[-ip a.b.c.d/e] [-gateway a.b.c.d]
[-public <default|<a.b.c.d/e>>
# valid vlan -id range (1-4094)
# -ip a.b.c.d/e if specified, the IP address/mask
# interface 0|2|3 (default is 0) of tenant
# e.g.> vlan v1 -id 3 -interface 0 -gate 10.1.0.1
Records a new VLAN tenant entry, along with the
appliance interface that VLAN tenant traffic will be
expected to use.
119