Schedule Command - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands

schedule command

WG#config<ENTER>
WG(config)#schedule
<"name"><enable|disable> [-all| \
-mon|-tue|-wed|-thu|-fri|-sat|-sun]
{hr:min-hr:min \
[hr:min-hr:min ][hr:min-hr:min ][hr:min-
hr:min ]}<ENTER>
Effect
Arguments
TIP
62
Use this command to set up a schedule for use in
the application of policies. Schedules can be set up
for the same hours for every day or for different
daily schedules, depending upon the arguments.
<"name">
Type a short, descriptive name for this schedule.
<enable|disable>
This argument specifies whether this schedule is
currently active or not.
-<day>
This argument defines the days of the week. The
values can either be noted as "all" for all seven
days, or include any combination of days of the
week–mon, tue, wed, thu, fri, sat, and sun.
{hour:minute-hour:minute}
This argument (which can be repeated for different
blocks of time) should note a range of hours, such
as "9:00-12:00" (which indicates 9:00am to Noon.)
Be sure to wrap the range in curly brackets, as
shown in the examples below. Hours must be
converted to and noted in military time–
according to the 24-hour clock.
A midnight start time should be entered as "0:00".
WatchGuard Vclass 5.1