Level 2 Ipsec Configuration Commands - Watchguard V10 Command Line Interface Manual

Apply interface address changes to appliance
WG#config<ENTER>
Effect
Arguments
Example
Results

Level 2 IPSec configuration commands

action command (configure IPSec level)
WG#config<ENTER>
WG(config)#ipsec <ENTER>
WG(config-ipsec)#action <"name"> \
< -tunnel_mode <*|peer_ip|address>| -
transport_mode> \
-auto_key [no] pfs_group <1|2> <"proposal-
name">... \
<"proposal-name"> -manual_key \
-esp <local_spi> <peer_spi> <des|3des> \
<ascii_key|%hex_key> <md5|sha>
<ascii_key|%hex_key> \
-ah <local_spi> <peer_spi> <md5|sha> \
<ascii_key|%hex_key>
WatchGuard Command Line Interface Guide
Second level configuration mode commands
WG(config)#interface<ENTER>
WG(config-if)#exit
Use this command to immediately apply any
interface address changes to this appliance. The
appliance will update you with status messages (as
shown below) to inform you about the process.
None
WG(config-if)# exit<ENTER>
Commit (Y/N)?y<ENTER>
...
interface 1 IP address is set to
16.10.203.121,
please wait for it to take effect...
WG(config)#
95