Level 3 Configuration Mode Commands; Level 3 Route Configuration Commands - Watchguard V10 Command Line Interface Manual

CHAPTER 3: Configuration Mode Commands
Example

Level 3 configuration mode commands

The following section, detailing all the third-level configu-
ration commands, has been divided into "task" or "topi-
cal" collections, which include the following:
• Route configuration this page
• Log configuration page 124

Level 3 route configuration commands

Configure new static route
WG#config<ENTER>
WG(config)#system<ENTER>
WG(config-sys)#route<ENTER>
WG(config-route)#static <destination> \
</prefix| mask> <gateway> interface <0|1|2>
122
the Radius server, if another than the default port
number is used.
<-radius_secret 'secret'>
This argument indicates the Radius password and
its text.
[-backup_radius_ip a.b.c.d] \
[backup_radius_port NUMBER]
This pair of arguments allows you to note a backup
Radius server and its port number, if present.
WG(config-tenant)#user_domain
<"MegaCo"> \
-interface 1 192.168.12.34 -id 6666 -
idle 720 \
-radius 12.12.3.144 \
-radius_secret "no_admit"<ENTER>
WatchGuard Vclass 5.1