Watchguard V10 Command Line Interface Manual page 88

CHAPTER 3: Configuration Mode Commands
Enable high availability
WG#config<ENTER>
WG(config)#high_availability <ENTER>
WG(config-ha)$
Setting Mode
[<primary|secondary> [interface N ip ] |
and statistics
Effect
Arguments
74
[active_standby | active_active]
[advanced]
[disable]
[hotsync]
[monitor <[0] [1]...[N]> <ON|OFF>]
[-name systemName2] ]
[no][shared_secret secret1]
show show current configuration
history show command history
exit go back to parent level
top go back to root level
Enables high availability in WatchGuard
appliances with one or more HA interfaces, and
assists you in entering precise HA system settings.
active_standby | active_active
This turns high availability on in either Active/
Standby mode or Active/Active mode. For more
information on these modes, see the Vcontroller
User Guide.
advanced
This enters advanced High Availability
configuration mode, and shows the following
prompt:
WG(config-ha-advanced)$
Enter Advanced
WatchGuard Vclass 5.1