Watchguard V10 Command Line Interface Manual page 98

CHAPTER 3: Configuration Mode Commands
| -auto]] |
[[no] dhcp_server -clients num [-lease_time num
[hours|days]]]
[dhcp_relay <a.b.c.d>]
# -lease_time default is 7 days
Effect
Arguments
84
-10_full_duplex|-10_half_duplex
Use this command to configure the network
identity of a WatchGuard appliance's interface 0
(Private).
<a.b.c.d>
This argument records the IP address assigned to
this interface.
</prefix|mask>
This argument records the number of bits in the
subnet mask (for example, "/16" is equivalent to
the address 255.255.0.0), or the actual subnet mask
address.
-mtu num
This allows you to set the size of the Maximum
Transmission Unit (MTU). The default is 1500
bytes.
[-100_full_duplex | -100_half_duplex|
-10_full_duplex|-10_half_duplex | -
auto]] |
This setting allows you to specify the speed at
which the interface will operate.
[[no] dhcp_server -clients num [-
lease_time num [hours|days]]]
This allows you to active the DHCP server service
on this interface, and specify information for it,
including the number of clients allowed DHCP
access, and the leasing time for a DHCP address.
The lease time default is 7 days.
WatchGuard Vclass 5.1