High Availability - Watchguard V10 Command Line Interface Manual

High Availability advanced configuration mode
WG#config<ENTER>
WG(config)#high_availability <ENTER>
WG(config-ha)#advanced
WG(config-ha-advanced)#
restart>]
prefix|mask>]
configuration and statistics
history
level
level
Effect
Arguments
WatchGuard Command Line Interface Guide
Second level configuration mode commands
[action <local | peer> <failover |
[ha2 <enable | disable>]
[primary <ha1|ha2> ip </
[secondary <ha1 ip>|
<ha2 ip </prefix|mask>>]
show
history
rename
exit
top
Allows you to configure advanced settings for

High Availability.

action <local | peer> <failover |
restart>
Allows you to manually failover or restart the local
or peer appliance of the HA pair. The local
appliance is the one you are connected to, and the
peer is its HA pair.
ha2 <enable | disable>
Allow you to enable the HA2 port for HA use.
When this is enabled, and the HA2 ports are
connected between the two appliances, in addition
show current
show command
rename an object
go back to parent
go back to root
77