Epson EMP-7950 User Manual page 98

Using the Configuration Menu Functions
TIP
The items appearing in the "Video" menu and the "About" menu will
vary depending on the type of input source being projected.
Select a setting value.
5
Tilt the [ ] button on the remote control or press the [ ] or [ ]
button on the projector's control panel to change setting values.
For items which are currently set, a appears in green next to
the setting. If you tilt the [ ] button on the remote control or
press the [ ] or [ ] button on the projector's control panel to
select an item to be set, the will appear in orange. After
making the selection, press the [Enter] button on the remote
control or the [Auto/Enter] button on the projector's control
panel to accept the setting. When the setting is accepted, the
changes to green.
:
Startup Screen ON OFF
:
Progressive
OFF Video
:
Color Adjustment
Color Temp. RGB
:
Rear Proj. ON OFF
:
Ceiling ON OFF
:
Standby Mode Network ON
Language Select [English]
Reset Execute
Film/Auto
Adjust
Network OFF
TIP
• Sub-menu items which cause another sub-menu to be displayed
when they are selected have
items and press the [Enter] button on the remote control or the
[Auto/Enter] button on the projector's control panel, you can then
change the settings in the next sub-menu which appears.
• Refer to "List of Functions" for details on the functions of each
menu item. p.78
Select other menu items in the same way.
6
Repeat steps 2 to 5 to change the settings for other menu items.
To return to a previous menu, press the [ESC] button on either
the remote control or the projector's control panel.
Close the menu.
7
Press the [Menu] button on either the remote control or the
projector's control panel.
TIP
The display position for configuration menus can be set to either the
top-left or the bottom-right of the images. If you press the [Menu]
button on either the remote control or the projector's control panel
twice in succession when displaying a configuration menu, the
configuration menu will be displayed in a different position from
before. If you would like to change configuration menu settings while
checking images, select an appropriate point in the projection and
then display the configuration menu.
User's Guide
after them. If you select such menu
97