Timer Loop; Timer Wait - 3Com 5500-EI PWR Reference Manual

Use the undo standby detect-group command to disable the interface backup function.
Examples
# Specify to enable VLAN-interface 2 (the backup interface) when the detected group 10 is
unreachable.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] standby detect-group 10
After the configuration, if detected group 10 is reachable, the backup interface VLAN-interface 2 will be
in the disabled state, and if detected group 10 is unreachable, VLAN-interface 2 will be enabled.

timer loop

Syntax
timer loop interval
undo timer loop
View
Detected group view
Parameters
seconds: Detecting interval. This argument ranges form 1 to 86,400 (in seconds) and defaults to 15.
Description
Use the timer loop command to set the detecting interval, that is, the frequency to perform auto detect
operations.
Use the undo timer loop command to restore the default.
By default, auto detect operations are performed on all detected groups every 15 seconds.
To monitor the destination IP address in real time, an Auto Detect-enabled switch detects all objects
within each detecting interval configured with the time loop command. During a detect operation, the
switch judges whether a destination IP address is reachable according to the time for waiting for an
ICMP Reply configured with the time wait command and the maximum retry times configured with the
retry command.
Examples
# Set the detecting interval to 60 seconds for detected group 10.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] detect-group 10
[Sysname-detect-group-10] timer loop 60

timer wait

Syntax
timer wait seconds
1-7