Garp Timer - 3Com 5500-EI PWR Reference Manual

Leave timer
LeaveAll timer
Hold timer
Related commands: garp timer, garp timer leaveall.
Examples
# Display the settings of the GARP timers on port Ethernet1/0/1.
<Sysname> display garp timer interface Ethernet 1/0/1
GARP timers on port Ethernet1/0/1

garp timer

Syntax
garp timer { hold | join | leave } timer-value
undo garp timer { hold | join | leave }
View
Ethernet port view
Parameters
hold: Sets the GARP Hold timer.
join: Sets the GARP Join timer.
leave: Sets the GARP Leave timer.
timer-value: Timeout time (in centiseconds) of the GARP timer (Hold, Join or Leave) to be set.
Description
Use the garp timer command to set a GARP timer (that is, the Hold timer, the Join timer, or the Leaver
timer) for an Ethernet port.
Use the undo garp timer command to restore the default setting of a GARP timer.
By default, the Hold, Join, and Leave timers are set to 10, 20, and 60 centiseconds.
Note that:
The setting of each timer must be a multiple of 5 (in centiseconds).
The timeout ranges of the timers vary depending on the timeout values you set for other timers. If
you want to set the timeout time of a timer to a value out of the current range, you can set the
timeout time of the associated timer to another value to change the timeout range of this timer.
The following table describes the relations between the timers:
Garp Join Time
Garp Leave Time
Garp LeaveAll Time
Garp Hold Time
: 20 centiseconds
: 60 centiseconds
: 1000 centiseconds
: 10 centiseconds
1-3