To Exit Hp Netraid Express Tools; B Hp Netraid Express Tools Management Menu - HP P3410A - NetRAID 1M RAID Controller User Manual

Chapter 4
Option: Experienced users may press <Ctrl> <M> for
HP NetRAID Express Tools now.
Firmware Initializing
When the system stops scanning, HP NetRAID Express Tools starts
immediately.

To exit HP NetRAID Express Tools

1. Press Esc at the Tools Management menu.
2. Choose Yes at the prompt.
3. Restart the HP NetServer.

B HP NetRAID Express Tools Management Menu

The HP NetRAID Express Tools Management menu options are described below.
The Configure menu provides several options for configuring physical
arrays and logical drives.
The Initialize option initializes one or more logical drives.
The Objects menu individually accesses adapters, logical drives, and
physical drives.
The Format option low-level formats selected hard disk drives.
The Rebuild option rebuilds failed disk drives.
The Check Consistency option ensures that parity or mirroring is correct
for the selected logical drive and remedies inconsistencies as necessary.
The Disable/Enable BIOS option disables the BIOS to boot off the
embedded SCSI instead of the adapter. The default setting is Enabled.
The Change Adapters option lets you select an adapter if more than one is
installed.
The Alarm Control option is available for HP NetRAID-1Si and
HP NetRAID-3Si. It lets you enable/disable the onboard tone generator or
silence it.
HP NetRAID Express Tools
77