HP P3410A - NetRAID 1M RAID Controller User Manual page 103

Chapter 4
Power Fail Safeguard, Alarm Control, and Cache Flush Timings. (You do
not need to record the configuration of your physical and logical drives.)
4. Remove the old HP NetRAID Series adapter and insert the new one
following these steps:
a. Turn off the system, unplug the power cord(s) from the system, remove
the HP NetServer cover or panel, and disconnect the SCSI cables from
the existing HP NetRAID Series adapter. Remove the existing adapter,
and place it on a grounding mat or other anti-static surface. If you have
removed an HP NetRAID or HP NetRAID-3Si adapter, disconnect the
Battery Backup Unit by unplugging the connector. (See "Battery
Backup Unit" in the HP NetRAID Series Installation and Configuration
Guide for complete information.)
b. Install the new HP NetRAID Series adapter, as described in the
HP NetRAID Series Installation and Configuration Guide. For
HP NetRAID-3Si, be sure to plug in the Battery Backup Unit.
c. Connect all SCSI cables to the HP NetRAID Series adapter.
d. Replace the HP NetServer cover or panel, plug in the power cord(s),
and turn on power to the HP NetServer.
5. After you see the flashing message "Firmware Initializing," this
message appears:
Configuration of NVRAM and drives mismatch for
Host Adapter X
Run View/Add Configuration option of Configuration
Utility
Press any key to enter the Configuration Utility.
This message tells you that the configuration information stored in the
drives (the correct configuration) does not match the configuration
information stored in NVRAM on the newly installed HP NetRAID
adapter.
NOTE If you have more than one HP NetRAID Series adapter
installed, the message tells you which adapter number has the
mismatch. Be sure to note which adapter needs to be
reconfigured.
6. Press any key and the HP NetRAID Express Tools utility starts
automatically. You see the Tools Management menu.
7. If you have more than one HP NetRAID Series adapter installed, do the
following to select the adapter you have just installed:
HP NetRAID Express Tools
97