System Settings - Dell 5130 Color Laser User Manual

Binary Used when no special processing is required for data.

System Settings

Use the System Settings menu to configure a variety of printer features.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
15 min.*
Sleep
5-30 min.
15 min.*
Deep Sleep
1-29 min.
Enter 5 to put the printer in power saver mode five minutes after it finishes a job. This uses much less energy, but
requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and you
notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 5 and 30 minutes for power save mode if you want a balance
between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the
computer or remote fax printer. You can also return the printer to the standby mode by pressing any button on the
operator panel.
Audio Tones
Purpose:
To configure settings for tones emitted by the printer during operation or when a warning message appears.
Values:
Off* Does not emit a tone when the operator panel input is correct.
Control
Panel
On
Off* Does not emit a tone when the operator panel input is incorrect.
Invalid Key
On
Off* Does not emit a tone when the printer becomes ready.
Machine
Ready
On
Off* Does not emit a tone when a job is complete.
Job
Completed
On
Off* Does not emit a tone when a job ends abnormally.
Fault Tone
On
Off* Does not emit a tone when a problem occurs.
Alert Tone
On
Off* Does not emit a tone when the printer runs out of paper.
Out of Paper
On
Specifies the time for transition to the power saver time (Sleep) in minutes.
Specifies the time for transition to the power saver time (Deep Sleep) in minutes.
Emits a tone when the operator panel input is correct.
Emits a tone when the operator panel input is incorrect.
Emits a tone when the printer becomes ready.
Emits a tone when a job is complete.
Emits a tone when a job ends abnormally.
Emits a tone when a problem occurs.
Emits a tone when the printer runs out of paper.