Dell 5130 Color Laser User Manual page 131

Re-enter
Community
Enter the community name used for trap again to confirm it.
1
Name (Trap)*
Select the check boxes to notify trap occurrence. In this case, specify the IP address and IP socket in
the following format:
Specify the IP address and IP socket in the nnn.nnn.nnn.nnn:mmmmm format. Each section of "nnn"
Trap is a variable value between 0 and 255. Note that values 127 and 224-254 are not valid for the first
Notification 1-4 three-digits only. IP socket mmmmm is a variable value between 0 and 65,535.
Specify the IP address and IP socket in the xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:mmmmm
format. Each section of "xxxx" is a hexadecimal variable value between 0 and ffff. IP socket
mmmmm is a variable value between 0 and 65,535.
Authenticate
Select the check box to notify Authenticate Error Trap.
Error Trap
1
* The default value of each items can be changed by using Dell Printer Configuration Web Tool.
SNMP v3
Purpose:
To edit the detailed settings of SNMP v3 protocol.
To enter this page, click Enable SNMP v3 Protocol in the SNMP page.
Values:
Administrator Account
Print Drivers / Remote
Client Account
Wireless LAN
Purpose:
To configure the detailed setting for the wireless network.
To use the wireless adapter, be sure to disconnect the network cable.
NOTE: Once wireless LAN is activated, wired LAN protocol will be disabled.
Values:
SSID
IPv4
IPv6
Account Enabled
User Name
Authentication
Password
Re-enter
Authentication
Password
Privacy Password
Re-enter Privacy
Password
Account Enabled
Reset to default
Password
Specifies the name that identifies the wireless network. Up to 32 alphanumeric characters.
Select the check box to enable the administrator account.
Enter the user name of the administrator account.
Specifies the authentication password of the administrator account
using 8 to 32 alphanumeric characters.
Enter the authentication password of the administrator account
again to confirm it.
Specifies the privacy password of the administrator account using 8
to 32 alphanumeric characters.
Enter the privacy password of the administrator account again to
confirm it.
Select the check box to enable the print drivers and remote client
account.
Click to reset the password for the print drivers and remote client
account to default.