Changing The Printing Speed - Ricoh Priport DX 4640PD Operating Instructions Manual

Basics
Note
❒ When you shift the image for-
ward, leave a 10 mm, 0.4" mar-
gin at the leading edge. If there
is no margin, paper might wrap
around the drum and cause a
misfeed.
2
❒ One push of either scroll key
shifts the image position by 0.25
mm, 0.01".
❒ The {T} and {U} keys shift the
image vertically by 10 mm, 0.4"
per press up or down for both
one- and two-sided printing. In
two-sided print mode, margins
at the top and bottom of the pa-
per apply equally to both front
and back. However, margins on
the right and left side of the pa-
per can be set individually.
❒ The {V} and {W} keys shift the
image laterally by 15 mm, 0.6"
per press right and left for one-
sided printing, or 2.5 mm, 0.1"
in either direction for two-sided
printing.
❒ When you reset to the default
position, press the {Initial posi-
tion} key.
C
Press [Exit].
D
Press the {Proof} key to check the
image position.
60

Changing the Printing Speed

Use the {W} or {V} key to adjust the
printing speed. The relationship be-
tween printing speed and print quali-
ty depends on the type of paper you
use.
Limitation
❒ When printing on paper longer than
364 mm or 14.4", the maximum print
speed is 120 sheets/minute.
❒ When selecting thick paper or spe-
cial paper on "Feed Tray Paper
Type", the maximum print speed
is 120 sheets/minute.
❒ When selecting duplex mode, the
m a x i m u m p r i n t s p e e d i s 1 2 0
sheets/minute.
❒ When duplex printing, the last page
prints at printing speed 1 regard-
less of the printing speed setting.