Verify A Card; Facility Codes; Card Types - Chamberlain Elite EL2000 Programming Manual

Verify that a card exists in the unit's database.
Audio Feedback "Invalid Step": Indicates the card Does Not exist in the database.
Audio Feedback "Valid Step": Indicates the card Exists in the database.
Press Then
1
Enter Card Number (1-65534 [26 or
2
30-bit]). Then (#)
Example:
1
Card number "43323" with Facility Code "1" and Card Type "30" is NOT valid.
Cards may be assigned facility codes that help identify one group from another, useful when managing
multiple buildings/complexes.
Enable or Disable Ignore the Facility Code When a Card is Used:
Unit will ignore Facility Codes when enabled. Factory Setting: Enabled.
Press
1
Enable (1) or Disable (0). Then (#)
2
Set the Default Facility Code:
Set a default Facility Code for 26-bit or 30-bit cards. If you set a default Facility Code,
every time a card is entered without one, the default Facility Code will be used.
Factory Setting: 0.
Press
1
Sets the default Facility Code for 26-bit or 30-bit cards to "1"
NOTE:
• If you assign a default Facility Code greater than 63, all 30-bit cards entered without a
Facility Code will be invalid. 30-bit cards have a Facility Code range of 0-63. 26-bit cards
have a Facility Code range of 0-255.
The EL Models accept two card types: Standard 26-bit cards or Sentex 30-bit cards.
Set the Default Card Type:
Use this to set a default card type (Standard 26-bit or Sentex 30-bit). If you set a default card
type, every time a card is entered without one, the default card type will be used.
Setting: Sentex 30-bit.
Press
1
Card Type (26 or 30). Then (#)
2

Verify a Card

Enter Facility Code (0-63 [30-bit] or 0-255 [26-bit]).
3
Then (#)
Card Type (26 or 30). Then (#)
3
2

Facility Codes

Then
73
Enter Facility Code (0-63 [30-bit], 0-255 [26-bit]).
2
Then
Then (#)
Example:
1

Card Types

73
Then
Example:
Sets the default card type to the Standard 26-bit.
Page 43
86
Then System Beeps ONCE
3 4
2
1
74
Factory
2