Activate Or Deactivate An Entry Code; Verify An Entry Code - Chamberlain Elite EL2000 Programming Manual

Delete ALL Entry Codes:
This will delete ALL Entry Codes from unit.
I mportant: Once you delete the Entry Codes, you cannot retrieve them unless they are saved
in Versa XS.
Press
1
Enter
2

Activate or Deactivate an Entry Code

This allows you to activate or deactivate an Entry Code, also on a specific date and time.
Activate / Deactivate an Entry Code:
Disabling the Activate Entry Code
Entry Code , then the four If statements could apply:
3
1. If you disable the Start Activation Date
times, the Entry Code will immediately become active and stay that way until the code is deactivated or
deleted.
2. If you enable the Start Activation Date
5
Deactivation Date , the Entry Code will activate on that "Start Date and Time".
3. If you disable the Start Activation Date
Date and Time" 5A 5B , the Entry Code will deactivate on that "End Date and Time".
4. If you enable the Start Activation Date
Deactivation Date 5 and add an "End Date and Time"
and Time" and deactivate on the "End Date and Time".
To Activate or Deactivate an Entry Code:
Press Then
1
Enter Entry Code (3-9 digits). Then (#)
2
Activate Entry Code, (Enable-1 or Disable-0). Then (#)
3
Use Start Activation Date, (Enable-1 or Disable-0).
4
Then (#)
Verify that an Entry Code exists in the unit's database.
Audio Feedback "Invalid Step": Indicates the code Does Not exist in the database.
Audio Feedback "Valid Step": Indicates the code Exists in the database.
Press Then
1
Enter Entry Code (3-9 digits). Then (#)
2
If you make an error during an entry, press the asterisk key (*) to begin again.
202
Then
Then
, the Entry Code will always be deactivated. If you enable the Activate
3
4 and disable the End Deactivation Date
4 and add only a "Start Date and Time"
4 and enable the End Deactivation Date
4 and add a "Start Date and Time"
5A 5B , the Entry Code will activate on that "Start Date

Verify an Entry Code

Page 38
56
5 and omit all dates and
4A 4B
and disable the End
5 and add only an "End
4A 4B
enable the End
Start Date (yymmdd). Then (#)
4A
Start Time (hhmm). Then (#)
4B
Use End Deactivation Date, (Enable-1
5
or Disable-0). Then (#)
End Date (yymmdd). Then (#)
5A
End Time (hhmm). Then (#)
5A
NOTE: All time must be entered using a
24-hour format (8AM=0800, 3PM=1500 etc.)
55