Auto Signal; Auto Setup - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

4 ) Adjust the light portion of RED.
z
In [RED] of [WHITE BALANCE HIGH], adjust
the 100 % of the white level of the image signal
to the position corresponding to 100 % on the
waveform monitor. (
5 ) Adjust [GREEN] and [BLUE] in a
similar manner.
Note
z
When the DVI-D signal, HDMI signal, or SDI signal is
inputted, check that the [DVI SIGNAL LEVEL], [HDMI
SIGNAL LEVEL], and [SDI SIGNAL LEVEL] are correctly
set before adjusting the black level.
z
The keystone cannot be applied to the waveform monitor
display.
z
The waveform monitor cannot be displayed in the [P IN P]
mode.
z
If the [P IN P] mode is set while the waveform is being
monitored, the waveform monitor will turn off.
z
The waveform monitor is not displayed while the on-
screen display is off.

AUTO SIGNAL

You can turn ON/OFF automatically detecting system
of the AUTO SETUP feature.
Press ▲▼ to select [AUTO SIGNAL].
1 )
Press ◄► to switch [AUTO SIGNAL].
2 )
z
The setting will change as follows each time
◄► is pressed.
OFF
Only when <AUTO SETUP> button
OFF is pressed, the projected image
position will be adjusted.
If unregistered signals are input
ON when [ON] is selected, auto setup
will be initiated automatically.
Æ
page 54)
ON
DISPLAY OPTION menu

AUTO SETUP

Use this setting when adjusting a specific or oblong
(16:9, etc.) signal.
Press ▲▼ to select [AUTO SETUP].
1 )
2 ) Press <ENTER> button.
z
The [AUTO SETUP] screen will be displayed.
Press ▲▼ to select [MODE].
3 )
Press ◄► to switch [MODE].
4 )
z
The setting will change as follows each time
◄► is pressed.
DEFAULT WIDE
To receive signals of which image
aspect is 4:3 or 5:4
(applicable resolution : 640 × 400,
640 × 480, 800 × 600, 832 × 624,
DEFAULT
960 × 720, 1 024 × 768,
1 152 × 864, 1 152 × 870,
1 280 × 960, 1 280 × 1 024,
1 600 × 1 200, 1 400 × 1 050)
To receive signals of which the
image aspect is wide
(applicable resolution: 720 × 400,
WIDE
848 × 480, 1 280 × 720,
1 024 × 600, 1 120 × 750,
1 440 × 900, 1 680 × 1 050)
To receive signals of specific
USER horizontal resolution (number of
horizontally displayed dots)
If [USER] is selected, press ◄► to
5 )
enter the horizontal resolution of
signal source into [DISPLAY DOTS].
6 ) Press <ENTER> button.
z
Execute automatic adjustment. A message
"PROGRESS..." appears during automatic
adjustment. When the adjustment is complete,
the system returns to the input screen.
USER
71
ENGLISH -