Remote 2 In Terminal - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

Technical Information

REMOTE 2 IN terminal

Using the [REMOTE 2 IN] terminal provided on the connection terminals of the main unit, it is possible to operate
the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot
be received.
Projector set up in a meeting room
J
Pin assignments and control
D-Sub 9-pin (Outside view)
Attention
z
Be sure to short-circuit Pins
z
When pin and pin
cannot be used.
<POWER ON ( I )> button, <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
z
When pin and pin
on the projector's control panel and on the remote control cannot be used.
<POWER> button, <INPUT SELECT> buttons (RGB1, RGB2, DVI-D, SDI, VIDEO, S-VIDEO), <SHUTTER> button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either.
z
The above is explanation in the case where "REMOTE2 MODE" of "PROJECTOR SETUP"
"STANDARD".
120
- ENGLISH
Pin No.
and when controlling.
are short-circuited, the following buttons on the projector's control panel and on the remote control
are short-circuited and then any one of pins
Remote control
Remote control/External control
RGB1
RGB2
DVI-D
Control panel located in a different room
Signal name Open (H)
GND
POWER OFF
RGB1 Other
RGB2 Other
VIDEO Other
S-VIDEO Other
DVI Other
SHUTTER OFF
Controlled by
RST/SET
remote control
to is short-circuited to pin
External control
Standby ON
LAMP
VIDEO
S-VIDEO
Short (L)
— GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI
ON
Controlled by
external contact
, the following buttons
Æ
( page 84) is set to