Color Temperature - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

PICTURE menu

COLOR TEMPERATURE

You can adjust the white balance of the projected
image.
Press ▲▼ to select [COLOR
1 )
TEMPERATURE].
Press ◄► or <ENTER> button.
2 )
z
The [COLOR TEMPERATURE] individual
adjustment screen will be displayed.
Press ◄► to switch [COLOR
3 )
TEMPERATURE].
z
The setting will change as follows each time
◄► is pressed.
Û
DEFAULT
9300K
Û
: [DEFAULT] cannot be selected when the
[PICTRUE MODE] has been set to [USER] or
[DICOM SIM.].
Note
z
When any setting other than [OFF] has been selected
for [COLOR MATCHING] (
TEMPERATURE] setting is fixed to [USER1].
z
The value of color temperature is for reference only.
J
To further adjust toward the
desired white balance
4 ) Select [USER1] or [USER2] in Step 3).
5 ) Press <ENTER> button.
z
The [COLOR TEMPERATURE] screen will be
displayed.
Press ▲▼ to select [WHITE
6 )
BALANCE].
7 ) Press <ENTER> button.
z
The [WHITE BALANCE] screen will be
displayed.
Press ▲▼ to select [WHITE
8 )
BALANCE HIGH] or [WHITE
BALANCE LOW].
9 ) Press <ENTER> button.
z
The [WHITE BALANCE HIGH (or LOW)]
screen will be displayed.
Press ▲▼ to select [RED], [GREEN]
10 )
or [BLUE].
54
- ENGLISH
USER1 USER2
(in units of 100K)
3200K
Æ
page 68), the [COLOR
Press ◄► to adjust the level.
11 )
Item Operation
Press ►.
Deepens red.
RED
Press ◄.
Weakens red.
Press ►.
Deepens green.
GREEN
Press ◄.
Weakens green.
Press ►.
Deepens blue.
BLUE
Press ◄.
Weakens blue.
Note
z
All colors will not be displayed properly unless adequate
adjustment is made. If the adjustment does not look
suitable, you can press <DEFAULT> button to return the
setting for the selected item only to the factory default
setting.
z
The [COLOR TEMPERATURE] cannot be adjusted
for the internal test pattern (
project the input signal when adjusting the [COLOR
TEMPERATURE].
J
Changing the name of [USER 1]
or [USER 2]
1. Select [USER1] or [USER2] in step 3).
2. Press <ENTER> button.
z
The [COLOR TEMPERATURE] screen will be
displayed.
Press ▲▼ to select [COLOR
3.
TEMPERATURE NAME CHANGE].
4. Press <ENTER> button.
z
The [COLOR TEMPERATURE NAME
CHANGE] screen will be displayed.
COLOR TEMPERATURE NAME CHANGE
Adjustment
Adjustment
range
Maximum
value
HIGH : 255
LOW : 127
Minimum
value
HIGH : 0
LOW :
- 127
Default
HIGH : 255
LOW : 0
Æ
page 88). Be sure to