Status - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

Q
When the D7700 Series is selected
Press ▲▼ to select input signal
1.
[DVI-D] or [SDI].
z
[RGB1], [RGB2], [VIDEO], [S-VIDEO] and
[HDMI] cannot be selected.
Since [RGB1], [RGB2], [VIDEO], and [S-VIDEO]
are already installed on the projector, another
input signal change command cannot be
assigned.
z
[SDI] is not shown for PT-DW8300U.
Press ◄► to select the input signal
2.
change command to be assigned to
the selected input signal.
z
The signal change command can be selected
to either [AUX] or [NONE].
z
The same input signal change command
cannot be assigned to both [DVI-D] and [SDI].

STATUS

Displays the status of the projector.
Press ▲▼ to select [STATUS].
1 )
2 ) Press <ENTER> button.
Press ◄► to move to the next page.
3 )
Displays the input selection
INPUT
state.
SIGNAL NAME Displays the input signal name.
SIGNAL Displays the frequency of the
FREQUENCY input signal.
PROJECTOR
Displays the projector runtime.
RUNTIME
Displays the lighting time of
*1
LAMP1
LAMP1.
Displays the lighting time of
*1
LAMP2
LAMP2.
INTAKE Displays the intake air
AIR TEMP. temperature of the projector.
OPTICS Displays the temperature inside
MODULE TEMP. the projector.
AROUND Displays the temperature around
LAMP TEMP. the lamp of the projector.
REMAINING
Displays the filter remaining
FILTER
quantity.
*2
QUANTITY
PROJECTOR
Displays type of projector.
TYPE
SERIAL Displays the serial number of the
NUMBER projector.
PROJECTOR SETUP menu
LAMP UNIT Displays the component number
MODEL NO. of the lamp unit.
LAMP1 SERIAL Displays the serial number for
NUMBER lamp1.
LAMP2 SERIAL Displays the serial number for
NUMBER lamp2.
Displays the main version of the
MAIN VERSION
firmware of the projector unit.
Displays the sub version of the
SUB VERSION
firmware of the projector unit.
NETWORK Displays the network version of
VERSION the projector unit.
EMULATE Displays the set emulate mode.
z
POWER ON TIMES :
Displays the number of times
the power has been turned
on.
z
LAMP1 ON :
ON COUNT
Displays the number of times
LAMP1 has been lit.
z
LAMP2 ON :
Displays the number of times
LAMP2 has been lit.
Displays the lighting time of
LAMP1
LAMP1. (HIGH or LOW)
Displays the lighting time of
LAMP2
LAMP2. (HIGH or LOW)
NUMBER OF Displays the number of
ENTRY SIGNAL registered signals.
REMOTE2 Displays [REMOTE 2 IN] control
STATUS status.
AC VOLTAGE Displays the AC voltage state.
*1 :
Lamp replacement time =
LAMP POWER [HIGH] lighting time +
(LAMP POWER [LOW] lighting time x 3 ÷ 4)
*2 : REMAINING FILTER QUANTITY
If the remaining quantity of ACF becomes 8%,
the status display turns yellow. If the remaining
quantity becomes 0%, the display turns red.
If the residual filter indication becomes yellow,
the remaining usable time is about 200 hours.
The time of 200 hours is for reference only. It
depends on the usage environment.
83
ENGLISH -