Serial Terminal - Panasonic PTDZ8700U - DLP PROJECTOR Operating Instructions Manual

Serial terminal

The serial connector which is on the connector panel of the projector conforms to the RS-232C interface
specification, so that the projector can be controlled by a personal computer which is connected to this connector.
J
Connection
●Single projector
Connecting terminals
on projector
D-Sub 9-pin (female)
D-Sub 9-pin (male)
Communication cable
(straight)
J
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
D-Sub 9-pin (male)
Outside view
J
Communication conditions (Factory setting)
Signal level
Sync. method
Baud rate
Parity
●Multiple projectors
Computer Computer
Pin No.
Pin No.
RS-232C-compliant
Asynchronous
9 600 bps
None
Technical Information
Connecting terminals
on projector 1
D-Sub 9-pin D-Sub 9-pin
(female) (male)
D-Sub 9-pin D-Sub 9-pin
(male) (female)
Communication cable
(straight)
Signal name
— NC
TXD Transmitted data
RXD Received data
— Connected internally
GND Earth
— NC
CTS
Connected internally
RTS
— NC
Signal name
— NC
RXD Received data
TXD Transmitted data
— NC
GND Earth
— NC
RTS
Connected internally
CTS
— NC
Character length
Stop bit
X parameter
S parameter
Connecting terminals
on projector 2
D-Sub 9-pin D-Sub 9-pin
(female) (male)
D-Sub 9-pin
(male)
Communication cable
(straight)
Contents
Contents
8 bits
1 bit
None
None
ENGLISH -
117