Serial In> / <Serial Out> Terminal - Panasonic PT-REZ12 Operating Instructions Manual

<SERIAL IN> / <SERIAL OUT> terminal
The <SERIAL IN> / <SERIAL OUT> terminal of the projector conforms with RS-232C so that the projector can be
connected to and controlled from a computer.
Connection
Single projector
D-Sub 9p (female)
D-Sub 9p (male)
Multiple projectors
D-Sub 9p (female)
Computer
Communication cable
When connecting using DIGITAL LINK compatible device
Projector connecting terminals
DIGITAL LINK
LAN cable (straight)
*1 When the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in the slot
Note
f The destination of [RS-232C] (x page 179) must be set according to the connection method.
f To control the projector with standby mode when connecting utilizing the DIGITAL LINK compatible device, set the [PROJECTOR SETUP]
menu → [STANDBY MODE] to [NORMAL].
When [STANDBY MODE] is set to [ECO], the projector cannot be control during standby.
f When using the contrast synchronization function/shutter synchronization function with <SERIAL IN> / <SERIAL OUT> terminal, refer to
"Connecting example when using the contrast synchronization function/shutter synchronization function" (x page 65) for details.
Pin assignments and signal names
D-Sub 9-pin (female)
Outside view
(6) (9)
(1) (5)
284 - ENGLISH
Chapter 7 Appendix — Technical information
Projector connecting terminals
D-Sub 9p (male)
Connecting terminals on projector 1
D-Sub 9p (male)
D-Sub 9p (male) D-Sub 9p (female)
DIGITAL LINK compatible device
*1
DIGITAL LINK
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Computer
Communication cable (straight)
Connecting terminals on projector 2
D-Sub 9p (female)
D-Sub 9p (male)
Communication cable
D-Sub 9p (female)
D-Sub 9p (male)
Communication cable (straight)
Signal name
― NC
TXD Transmitted data
RXD Received data
― NC
GND Earth
― NC
CTS
Connected internally
RTS
― NC
D-Sub 9p (male)
Computer
Details