Encryption Key Exchange Settings Configuration Flow; Specifying Encryption Key Exchange Settings - Ricoh Aficio SP 3500N Software Manual

9. Appendix

Encryption Key Exchange Settings Configuration Flow

This section explains the procedure for specifying encryption key exchange settings.
1. Set the IPsec settings on Web Image Monitor.
2. Enable IPsec settings.
• After configuring IPsec, you can use "ping" command to check if the connection is established
correctly. Also, because the response is slow during initial key exchange, it may take some time to
confirm that transmission has been established.
• If you cannot access Web Image Monitor due to IPsec configuration problems, disable IPsec on
the control panel, and then access Web Image Monitor.
• For details about enabling and disabling IPsec using the control panel, see p.123 "Enabling and
Disabling IPsec Using the Control Panel"

Specifying Encryption Key Exchange Settings

• To display [IPsec Settings] menu, specifying an administrator password is required.
1. Start the Web browser, and access the printer by entering its IP address.
2. Click [IPsec Settings].
3. Click the [IPsec Policy List] tab.
4. Select the number of the setting you want to modify in the list, and then click [Change].
5. Modify the IPsec related settings as necessary.
6. Enter the administrator password, and then click [Apply].
7. Click the [IPsec Global Settings] tab, and then select [Active] in [IPsec Function].
8. If necessary, specify [Default Policy], [Broadcast and Multicast Bypass], and [All ICMP
Bypass] also.
9. Enter the administrator password, and then click [Apply].
120
Printer
3. Confirm IPsec transmission.
PC
1. Set the same IPsec settings as the printer on PC.
2. Enable IPsec settings.