Operator Panel Tasks; Putting The Printer Online Or Offline; Stopping A Job; Clearing The Print Buffer - NEC 1760 - SilentWriter B/W Laser Printer User Manual

Operator Panel Tasks

This section describes some of the basic tasks you
perform using the operator panel.

Putting the Printer Online or Offline

Press the Online button to switch between the online
and offline states.
note:
The printer must be offline before you can
change any printer settings. It must be online (indicator
light on) to print.

Stopping a Job

If you wish to stop a print job before it is complete
1. Press the Reset button for less than 4 seconds. The
status display message
QUITTING THE JOB OK?
appears. The job will continue to print until you...
2. Press the Select button to quit the job, or...
press the Online button to return to normal
printing.

Clearing the Print Buffer

The print buffer is an electronic memory in the printer
where data is kept before processing. To print out any
data that is in the print buffer, press the Feed button.

Resetting the Printer

To clear the printer buffer of data (including temporarily
downloaded fonts), press and hold the Reset button for
4 seconds until appears on the status
RESETTING
display. Printer performs an internal diagnostic and
then returns to online state.
3–4 User's Guide

Restoring Settings to Factory Defaults

To restore printer to the factory default settings, follow
these steps
1. Turn off the printer.
2. While pressing the Feed and Online buttons, turn
on the printer. When the display changes to
, release the buttons.
FACTORY SETTINGS
All downloaded fonts are lost and the printer's name is
reset to its factory default
note:
For the 1765, the IP address is reset to
11.22.33.44 and the AppleTalk zone is reset to *.

Printing a Demo Page

You can print a demo page that displays text and
graphic samples for verifying print quality.
1. On the operator panel, press the Online button to
turn the indicator light off and take the printer
offline. The display changes from
.
NOT READY
2. Press Test to print the demo page.
appears on the operator panel
PROCESSING DEMO
display, and then it changes to
printer begins to print the demo page. Upon
completing the print job, the printer returns to the
offline state.
3. Press Online to put the printer back online.
note:
See page 4-21 for instructions on printing a
test page and font lists. Pages 3-8 to 3-10 show a flow
diagram of the operator panel menu tree.
to
READY
. The
PRINTING DEMO