Table of Contents
Advertisement
PS Menu Item
PAGEPROT
COPIES
PRINT ERRS
EDGE-EDGE
IPDS Menu
The following table describes the settings you can change from the IPDS
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The IPDS Menu appears only if you have the IPDS SIMM installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
2. Values specified in IPDS print jobs override IPDS Menu values set at the
printer.
Value
AUTO*
Sets page protection:
ON
v AUTO—the printer protects the minimum amount of
v ON—the printer reserves enough memory to process an
nnn
Specifies how many copies of each job to print. nnn can be
from 1 to 999. 1 is the default.
OFF*
Specifies how the printer handles PostScript errors:
ON
v OFF—the printer cancels the job, but does not print an
v ON—the printer prints an error page and cancels the job.
ON*
Turns edge-to-edge printing on or off.
OFF
v ON—The printer allows printing up to the physical page
v OFF—the printer maintains a border of 4 mm on all four
Notes:
1. IBM recommends leaving EDGE-EDGE set to ON when
2. The IBM printer driver cannot override the OFF setting.
memory necessary.
entire page without compression before it prints the page.
This can help in the rare case where the printer
compression scheme causes a loss of quality in complex
graphics. This setting is available only when the printer
has enough memory. See "Memory Requirements" on
page 8 for more information.
error page.
size.
paper sides.
you use IBM printer drivers. If you use non-IBM printer
drivers, you may need to set EDGE-EDGE to off to
prevent toner contamination in the printer.
If you set EDGE-EDGE to OFF, you cannot print
edge-to-edge.
Description
Chapter 6. Operator Panel Menus
111
Advertisement
Table of Contents
