Table of Contents
Advertisement
IPDS Menu Item
FONT CAPTURE
Token Ring Menu
For information about configuring the token-ring attachment, please see
Ethernet and Token Ring Quick Configuration Guide, which comes with the
token-ring network interface card. "Chapter 9. Configuring Printer
Network Addresses" on page 211 describes how to define the IP address,
default gateway address, and subnet mask from the operator panel.
Use the Token Ring Menu to configure the token-ring attachment. The
following table describes the settings you can change from the Token Ring
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The Token Ring Menu appears only if you have the token-ring attachment
installed.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that is now active.
2. If you are unfamiliar with using the operator panel to work with menus,
please read "Using the Operator Panel Keys" on page 23 and "Navigating
Menus" on page 24 before continuing.
Value
ON*
OFF
Important!
Sets FONT CAPTURE processing:
v ON—allows the printer to save downloaded font
resources onto the hard disk for use beyond power
cycles. The IPDS host must provide the Activate Resource
command with proper resource identifiers prior to
downloading the font resource to be captured.
v OFF—the printer will not save downloaded font
resources after a power cycle.
Description
Chapter 6. Operator Panel Menus
121
Advertisement
Table of Contents
