8. If the problem involves spots or streaks, print several test pages to clean
out contamination.
9. If the problem is with complex graphics or images and the message MRT
COMPRESSION displays, try changing the PAGEPROT menu item to ON.
This item can be individually set in specific data stream menus (PCL
Menu, PS Menu, or IPDS Menu.) You may also need more memory. See
"Memory Requirements" on page 8 for information about memory
requirements.
10. If you have an EDGE-EDGE setting set to ON, set it to OFF. EDGE-EDGE
11. Consider replacing the fuser. See "Changing the Usage Kit" on page 152.
Print Is Too Light
Possible Causes
Economy mode is set on.
Density is set too low.
There is moisture in the
paper.
The toner cartridge is low
on toner.
The toner cartridge is
damaged or life exceeds
23,000 pages.
226
Infoprint 32 and Infoprint 40: User's Guide
can be found on the following menus:
v "PCL Menu" on page 106
v "PS Menu" on page 110
v "Coax Setup Menu" on page 134
v "Twinax Setup Menu" on page 136
v "IPDS Menu" on page 111
Actions You Should Take
Make sure economy mode is not set.
Check your print driver settings and
also see "Configuration (Config)
Menu" on page 102.
Reset it to a higher value if
necessary. See "Configuration
(Config) Menu" on page 102.
Load fresh, dry paper.
Replace the toner cartridge. See
"Changing the Toner Cartridge" on
page 144.
Replace the toner cartridge. See
"Changing the Toner Cartridge" on
page 144.
Print Sample