Table of Contents
Advertisement
PS Menu Item
AUTO*
PAGEPROT
ON
COPIES
nnn
OFF*
PRINT ERRS
ON
ON*
EDGE-EDGE
OFF
IPDS Menu
The following table describes the settings you can change from the IPDS
Menu. An asterisk (*) next to a value in the table indicates the factory default.
The IPDS Menu appears only if you have the IPDS SIMM installed.
104
InfoPrint 20: User's Guide -- CD Version
Value
Sets page protection:
v AUTO—the printer protects the minimum amount of
memory necessary.
v ON—the printer reserves enough memory to process an
entire page without compression before it prints the page.
This can help in the rare case where the printer
compression scheme causes a loss of quality in complex
graphics. This setting is available only when the printer
has enough memory. See "Memory Requirements" on
page 5 for more information.
Specifies how many copies of each job to print. nnn can be
from 1 to 999. 1 is the default.
Specifies how the printer handles PostScript errors:
v OFF—the printer cancels the job, but does not print an
error page.
v ON—the printer prints an error page and cancels the job.
Turns edge-to-edge printing on or off.
v ON—The printer allows printing up to the physical page
size.
v OFF—the printer maintains a border of 4 mm on all four
paper sides.
Notes:
1. IBM recommends leaving EDGE-EDGE set to ON when
you use IBM printer drivers for InfoPrint 20. If you use
non-IBM printer drivers, you may need to set
EDGE-EDGE to off to prevent toner contamination in the
printer.
2. The IBM printer driver cannot override the OFF setting.
If you set EDGE-EDGE to OFF, you cannot print
edge-to-edge.
Description
Advertisement
Table of Contents
