Drive Chain - HYOSUNG GT 650 Service Manual

● Add new engine oil and check the oil level as
described in the engine oil replacement procedure.
CAUTION
Use HYOSUNG MOTORS GENUINE OIL FILTER
only, since the other make' s genuine filters and
after-market parts may differ filtering perfor-
mance and durability, which could cause engine
damage or oil leaks. Hyosung motors genuine oil
filter is also not usable for the motocycles.

DRIVE CHAIN

Inspect Interval
Clean and Lubricate Every 1,000 km.
Visually check the drive chain for the possible defects
listed below. (Support the motorcycle by the jack
or block, turn the rear wheel slowly by hand with the
trans-mission shifted to Neutral.)
● Loose pins
● Excessive wear
● Damaged rollers
● Improper chain adjustment
● Missing X-Oring seals
● Dry or rusted links
● Kinked or binding links
If any defects are found, the drive chain must
be replaced.
Damage to the drive chain means that the sprock-
et may also be damaged.
If any defects are found, the sprocket must be
replaced.
NOTE
When replacing the drive chain, replace the
drive chain and sprocket as a set.
◉ INSPECTION OF DRIVE CHAIN
LENGTH
● Loosen the axle nut ①.
● Loosen the lock nuts ②, ③.
● Tense the drive chain fully by turning both chain
adjusters ④, ⑤.
PERIODIC MAINTENANCE 2-12
Normal wear
②
⑤
Excessive wear
④
①
③