Mini-Pci Video Adapter - IBM 8647 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

Mini-PCI video adapter

Before you begin:
v Read "Safety information" on page 131
v Review the information in "System reliability considerations" on page 37
To remove the mini-PCI card, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server, and disconnect the power cord; then, disconnect all external
3. Remove the side cover. See "Removing the side cover" on page 41
4. Remove the frame-support bracket. See "Removing the frame-support bracket"
5. Remove both adapter-retaining brackets and the adapter in PCI adapter slot 1
6. Disconnect the cables.
7. Remove the air flow guide and the air baffle from over the microprocessor.
8. Find the video adapter in the mini-PCI type III slot on the system board, and
9. Using a pair of pliers, squeeze the stand-off pins and pull the mini-PCI card up
90
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
cables.
on page 43
(see "Installing an adapter" on page 46).
remove the video cable from the connector on the adapter.
and out of the slot.