Diskette drive
Before you begin:
v Read "Safety information" on page 131
v Review the information in "System reliability considerations" on page 37
To remove the diskette drive, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server, and disconnect the power cord; then, disconnect all external
3. Remove the side cover. See "Removing the side cover" on page 41
4. Disconnect the cables.
5. Remove the two screws from the diskette drive cage.
6. Gently slide the diskette drive toward the front of the server and lift it out.
To replace the diskette drive, reverse the steps.
96
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
cables.