Post Error Codes - IBM 8647 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

Note: See "System replaceable units" on page 124 to determine which components should be replaced by a field
service technician.
AC good LED DC good LED
On Off
On On

POST error codes

In the following error codes, X can be any number or letter.
Note: See "System replaceable units" on page 124 to determine which components should be replaced by a field
service technician.
Error code/symptom
062
(Three consecutive boot failures using the
default configuration.)
101, 102, 106
(Timer tick interrupt failure)
102
(Timer 2 test failure)
106
(Diskette controller error)
129
(Internal cache (L1) error)
151
(Real time clock error)
161
(Real time clock battery error)
112
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
Description
Standby mode or dc
problem.
Power is working properly.
FRU/action
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
4. Microprocessor.
System board
System board
System board
1. Optional microprocessor
2. Microprocessor
1. Run diagnostics.
2. Battery.
3. System board.
1. Run the Configuration/Setup Utility program.
2. Battery.
3. System board.
FRU/action
1. Check system board cable connectors
Power1 and Power2. If the dc good LED is
lit, press Ctrl+Alt+Delete. Watch the screen
for any POST errors. Check the System
Error Log for any listed problems. If the
system starts with no errors:
a. Power switch assembly
b. System board
2. Remove the adapters and disconnect the
cables and power connectors to all internal
and external devices. Turn on the system.
If the dc good LED is lit, replace the
adapters and devices one at a time until
you isolate the problem.
3. Power supply.
4. Power cage assembly, if installed.
5. System board.
N/A