Removing the frame-support bracket
When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the frame-support bracket to access the device.
Complete the following steps to remove the frame-support bracket:
1. Review Safety information beginning on page 131 and "Installation guidelines"
2. Remove the side cover ("Removing the side cover" on page 41).
3. If your server comes with a standard support bracket similar to the support
on page 37
bracket in the following illustration, complete the following steps:
a. Pull out on the rear end of the support bracket at a 45° angle.
b. Disengage the front end of the support bracket from the server and set the
bracket aside.
Chapter 4. Installing options
43