Cabling An Optional Scsi Adapter - IBM 8647 - Eserver xSeries 225 Maintenance And Troubleshooting Manual

10. If you have another adapter to install, repeat steps 3 through 9
11. If you have installed a full-length adapter, rotate the front adapter-support
12. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the
13. If you have other options to install, do so now; otherwise, go to "Completing

Cabling an optional SCSI adapter

You can install an optional SCSI adapter in your server to control the internal hard
disk drives. With a SCSI adapter installed, you can configure the internal hard disk
drives into disk arrays. You can also cable a SCSI adapter to external hard disk
drives. See your SCSI adapter option documentation for complete instructions for
installing a SCSI adapter in your server and for additional information about SCSI
adapters.
48
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
8. Carefully grasp the adapter by the top edge or upper corners, and align it with
the expansion slot guides; then, press the adapter firmly into the expansion
slot. Move the adapter directly from the static-protective package to the
adapter slot.
Expansion-slot
cover
Rear adapter-
retaining
bracket
9. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans. If you are installing an optional SCSI adapter, see
"Cabling an optional SCSI adapter" for additional information.
bracket to the closed (locked) position.
closed (locked) position.
Note: If any adapters in your server are large or have heavy cables attached
to them, you can remove the rear adapter-retention bracket and secure
all of the adapters with expansion-slot screws. The expansion-slot
screws are stored on the back of the server next to slot 1.
the installation" on page 71
Adapter
Front adapter-
retaining bracket