Default Configuration - Cisco IE-3000-8TC Software Configuration Manual

Configuring PTP

Default Configuration

By default, PTP is enabled on all the Fast Ethernet and Gigabit Ethernet ports on the base switch module.
Only the ports on the base switch module are PTP-capable. The switch expansion modules do not
support PTP. The default PTP mode on all ports is end-to-end transparent.
Table 9-1 Default PTP Configuration
Feature
PTP boundary mode
PTP forward mode
PTP transparent mode
PTP priority1 and PTP priority2
PTP announce interval
PTP announce timeout
PTP delay request interval
PTP sync interval
PTP sync limit
Cisco IE 3000 Switch Software Configuration Guide
9-2
Default Setting
Disabled
Disabled
Enabled
Default priority number is 128
2 seconds
8 seconds
32 seconds
1 second
50000 nanoseconds
Chapter 9 Configuring PTP
OL-13018-03