Configuring Lldp, Lldp-Med, And Wired Location Service; Default Lldp Configuration - Cisco IE-3000-8TC Software Configuration Manual

Configuring LLDP, LLDP-MED, and Wired Location Service

•
•
•
•
When the switch shuts down, it sends an attachment notification with the state delete and the IP address
before closing the NMSP connection to the MSE. The MSE interprets this notification as disassociation
for all the wired clients associated with the switch.
If you change a location address on the switch, the switch sends an NMSP location notification message
that identifies the affected ports and the changed address information.
Configuring LLDP, LLDP-MED, and Wired Location Service
•
•
•
•
•
•
•

Default LLDP Configuration

Table 27-1
Feature
LLDP global state
LLDP holdtime (before discarding)
LLDP timer (packet update frequency)
LLDP reinitialization delay
LLDP tlv-select
LLDP interface state
LLDP receive
LLDP transmit
LLDP med-tlv-select
Cisco IE 3000 Switch Software Configuration Guide
27-4
Device category is specified as a wired station
State is specified as delete
Serial number, UDI
Time in seconds since the switch detected the disassociation
Default LLDP Configuration, page 27-4
Configuration Guidelines, page 27-5
Enabling LLDP, page 27-5
Configuring LLDP Characteristics, page 27-5
Configuring LLDP-MED TLVs, page 27-6
Configuring Network-Policy TLV, page 27-7
Configuring Location TLV and Wired Location Service, page 27-9
Default LLDP Configuration
Chapter 27 Configuring LLDP, LLDP-MED, and Wired Location Service
Default Setting
Disabled
120 seconds
30 seconds
2 seconds
Disabled to send and receive all TLVs
Disabled
Disabled
Disabled
Disabled to send all LLDP-MED TLVs
OL-13018-03