Configuring Snmp Traps For Rep; Monitoring Rep - Cisco IE-3000-8TC Software Configuration Manual

Chapter 21 Configuring Resilient Ethernet Protocol
Command
Step 1 rep preempt segment segment-id
Step 2
show rep topology

Configuring SNMP Traps for REP

You can configure the switch to send REP-specific traps to notify the SNMP server of link operational
status changes and port role changes. Beginning in privileged EXEC mode, follow these steps to
configure REP traps:
Command
Step 1 configure terminal
Step 2 snmp mib rep trap-rate value
Step 3 end
Step 4 show running-config
Step 5
copy running-config startup config
To remove the trap, enter the no snmp mib rep trap-rate global configuration command.
This example configures the switch to send REP traps at a rate of 10 per second:
Switch(config)# snmp mib rep trap-rate 10

Monitoring REP

Use the privileged EXEC commands in
Table 21-1 REP Monitoring Commands
Command
show interface [interface-id] rep [detail]
show rep topology [segment segment_id]
[archive] [detail]
OL-13018-03
Purpose
Manually trigger VLAN load balancing on the segment.
You will need to confirm the command before it is executed.
View REP topology information.
Purpose
Enter global configuration mode.
Enable the switch to send REP traps, and set the number of
traps sent per second. The range is from 0 to 1000. The default
is 0 (no limit imposed; a trap is sent at every occurrence).
Return to privileged EXEC mode.
Verify the REP trap configuration.
(Optional) Save your entries in the switch startup configuration
file.
Table 21-1to monitor REP.
Purpose
Displays REP configuration and status for an interface or for all interfaces.
Displays REP topology information for a segment or for all segments,
including the primary and secondary edge ports in the segment.
Cisco IE 3000 Switch Software Configuration Guide
Monitoring REP
21-13