Configuring A Guest Vlan - Cisco IE-3000-8TC Software Configuration Manual

Configuring 802.1x Authentication
Command
Step 6
show running-config
Step 7
copy running-config startup-config
Use the show radius statistics privileged EXEC command to display the number of RADIUS messages
that do not receive the accounting response message.
This example shows how to configure 802.1x accounting. The first command configures the RADIUS
server, specifying 1813 as the UDP port for accounting:
Switch(config)# radius-server host 172.120.39.46 auth-port 1812 acct-port 1813 key rad123
Switch(config)# aaa accounting dot1x default start-stop group radius
Switch(config)# aaa accounting system default start-stop group radius

Configuring a Guest VLAN

When you configure a guest VLAN, clients that are not 802.1x-capable are put into the guest VLAN
when the server does not receive a response to its EAP request/identity frame. Clients that
are 802.1x-capable but that fail authentication are not granted network access. The switch supports guest
VLANs in single-host or multiple-hosts mode.
Beginning in privileged EXEC mode, follow these steps to configure a guest VLAN. This procedure is
optional.
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3
switchport mode access
Step 4 authentication port-control auto
or
dot1x port-control auto
Step 5 dot1x guest-vlan vlan-id
Step 6 end
Step 7
show authentication interface-id
or
show dot1x interface interface-id
Step 8 copy running-config startup-config
To disable and remove the guest VLAN, use the no dot1x guest-vlan interface configuration command.
The port returns to the unauthorized state.
Cisco IE 3000 Switch Software Configuration Guide
12-42
Chapter 12
Purpose
Verify your entries.
(Optional) Saves your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the port to be configured, and enter interface configuration mode.
For the supported port types, see the
Configuration Guidelines" section on page
Set the port to access mode.
Enable 802.1x authentication on the port.
Specify an active VLAN as an 802.1x guest VLAN. The range is 1
to 4094.
You can configure any active VLAN except an RSPAN VLAN or a voice
VLAN as an 802.1x guest VLAN.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring IEEE 802.1x Port-Based Authentication
"802.1x Authentication
12-28.
OL-13018-03