ENGINE HANGER SIDE COVER
● Loosen the 2 washer screw securing the engine hanger
side cover.
● Install in the reverse order of removal.
FRONT COVER
● Loosen the upper cover set screws (R/L) securing the
inner box.
● Loosen the upper cover set screws (R/L) securing the
front under cover.
● Loosen the special bolt securing the front of the front
cover.
● Draw the upper part of the front cover to remove it.
● Disconnect the head light wiring and remove the front
cover.
● Install in the reverse order of removal.
NOTE
•Check for proper alignment of the connection (hook)
before performing installation.
FRONT FENDER
● Loosen the flange bolts (R/L) securing the front fork.
● Remove the front fender.
● Install in the reverse order of removal.
INNER BOX
● Remove the center cover. ( 3-3)
● Remove the floor side cover. ( 3-4)
● Remove the floor panel. ( 3-4)
● Remove the front cover. ( 3-5)
● Loosen the tapping screws (R/L) securing the front
under cover.
● Loosen the special bolts securing the right and left
sides of the front cover.
● Turn the main key cover slightly to release the locking
and remove the cover.
● Remove the cover set screw securing the back holder,
take off the joint part of the front under cover and
remove the inner box.
● Install in the reverse order of removal.
WASHER SCREW
SETTING
SCREW
SETTING SCREW
SPECIAL SCREW
EXTERNAL PARTS
SPECIAL BOLT
SPECIAL SCREW
TAPPING
SCREW
3-5