DAELIM S-FIVE Service Manual page 110

FRONT WHEEL/FRONT FORK/STEERING
● If the tire has an light mark (yellow paint mark), install
the tire with this mark aligned with the valve.
● If the tire has an arrow mark, install the tire with the
mark pointing in the direction of rotation.
● Stand the tire upright, hold it with one hand and,
starting from the opposite side to the valve, install one
side of the tire on the rim as much as you can by hand.
● Be sure to assemble in the sequence shown.
● Place the wheel on the level surface and install the
remaining portion of the tire using two tire levers.
NOTE
·For easy assembly, apply a mild detergent solution to
the tire and rim mating surfaces.
·Do not use the detergent solution on the tire and rim
mating surfaces of the low pressure tires. Use water
only.
● Install the other side of the bead while holding the
assembled portion of the bead with your knee to
prevent it from coming off.
NOTE
·Before using the levers, be sure that the bead on the
opposite side is positioned in the center of the rim.
● Install the bead a little at a time; using care not to
damage the tube or wheel with the tire levers.
● After 1/2 of the bead has been installed, insert the two
tire levers at a distance of 30~40mm to install it.
Repeat this procedure until 3/4 of the bead has been
installed.
NOTE
·Hold one tire lever upright to remove the other lever.
10-12