DAELIM S-FIVE Service Manual page 102

FRONT WHEEL/FRONT FORK/STEERING
● Install the rear brake cable, front brake hose,
speedometer cable to the handle cable guide.
● Apply DAELIM Bond A to the inside surface of the
grip and to the clean surface of the left handle bar. Wait
3~6 minutes and install the grip.
(Bond A :ROYAL BOND 1300)
NOTE
·Clean the bonding surface to avoid oil, grease or
gasoline from attatching.
·Leave it for minimum 1 hour until the bond is dried.
·Use the bond according to the bond manual enclosed
and install the grip while rotating it before the bond is
dried completely.
● Align the positioning pin with the handle hole and
install the L. handle bracket.
TORQUE : 1.2kgf·m
● Clean the throttle grip surface, apply the grease and
install the grip.
● Connect the throttle cable to the groove of the grip.
● Tighten the pin screws after assembling the under and
upper throttle housings.
NOTE
·Check the throttle grip for smooth operation and
adjust the free play to 2~6mm.
● Match the master cylinder with the punch mark of the
handle, install it with the mark in the master cylinder
holder facing upwards or front and tighten the rear or
front first.
NOTE
·Check to see if the cylinder is passing each cable and
wire harness directly and make sure that there is any
interference by rotating the handle to the right and
left.
● Install the rear handle cover. ( 3-6 )
● Install the front handle cover. ( 3-6 )
● Install the front cover. ( 3-5 )
10-4