Table of Contents
Advertisement
28
Using Symantec Ghost as a stand-alone program
Cloning disks and partitions
Cloning partition to partition
6
When the "Proceed with disk clone?" prompt appears, do one of the following:
To proceed with the disk
cloning.
To return to the menu.
Warning: Only click Yes if you are sure that you want to proceed. The
destination disk is overwritten with no chance of recovering any data.
7
Restart the computer.
Warning: You should remove one of the hard disks before you restart your
computer. If you leave two hard disks in the computer, damage can occur to
both of the bootable operating systems.
8
Verify the integrity of the destination disk.
See
"Verifying integrity"
You can also run Symantec Disk Doctor, Chkdsk, ScanDisk, or a similar utility
to verify the integrity of the destination disk.
When you clone partition to partition, Ghost.exe copies the contents of one
partition onto another.
To clone from partition to partition
1
On the main menu, do one of the following:
Local
Peer-to-peer connection
2
In the Source Drive dialog box, select the source disk.
The Source Drive dialog box shows details of every disk that Ghost.exe finds
on the local computer.
Click Yes.
The system performs an integrity check of the file
structure on the source disk, and then copies the
source disk to the destination. If you need to abort
the process, press Ctrl+C, but be aware that this
leaves the destination disk in an unknown state.
Click No.
on page 30.
Click Local > Partition > To Partition.
Click Partition >To Partition.
Advertisement
Table of Contents
