Using The -Crc32 Switch - Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual

Using the -CRC32 switch

:PROBLEM
ECHO Symantec Ghost returned with an Error value 1 or higher
ECHO Symantec Ghost operation was not completed successfully
REM **Add any commands required to run if Symantec Ghost
REM fails here **
:FINISH
ECHO Batch File Finished
CRC checking works file-by-file with FAT partitions. NTFS partitions are
CRC-checked within an image file by each MFT table. It is not possible at present
to obtain a list of files failing a CRC check with an NTFS file system. When a CRC
file is created for an NTFS partition, only a single CRC value is generated. You can
also create a CRC file from an image file and verify it against a disk.
The full syntax for this switch is as follows:
-CRC32,action={create|verify|pcreate|pverify|dcreate|dverify},
src={{disk}|{partition}|{file}},crcfile={file}|{partition},vlist={file},
vexcept={file}
Table B-10 describes the parameters that can be used with the -CRC32 switch.
Parameters for the -CRC32 switches
Table B-10
Parameter Explanation
create Create an ASCII CRC32 file from a disk
verify Verify a disk from a CRC32 file
pcreate Create an ASCII CRC32 file from a partition
pverify Verify a partition from an ASCII CRC32 file
dcreate Create an ASCII CRC32 file from an image file
dverify Verify an image file from an ASCII CRC32 file
crcfile ASCII CRC32 file (default=Ghost.crc)
vlist Verification list file (default=Ghost.ls)
vexcept Verification exception file (no default)
Command-line switches
Using the -CRC32 switch
157