Table of Contents
Advertisement
172
Troubleshooting
Ghost.exe problems
Ghost.exe problems
Error messages (continued)
Table E-1
Error code
Description
10098
The partition number must be included in the command-line
switches.
See
10010
Incorrect path/file syntax. Ensure that the path and file name are
correct. Also make sure that you have the proper user rights to
read or create the image file.
19906
Symantec Ghost was unable to establish a connection with the
GhostCast Server.
19910, 20070
No packet driver was found.
See
19913
Cannot find the BOOTP/DHCP server. Ensure that the computer
is connected to the network and that a BOOTP or DHCP server is
set up for this subnet.
19916
Duplicate IP address detected. An IP address has been allocated
that is already in use.
19900
The GhostCast session is set up incorrectly. Ensure that the TCP/IP
settings are correct.
29005
If you restore an image to a disk configured as a dynamic disk
with a single simple volume on it on a Vista RTM Ultimate
computer then Ghost32 fails with the following error: write sector
failure 29005.
The workaround is as follows: In Disk Manager, convert the disk
to an mbr disk and then restore the image.
CDR101: Not ready
A system error message. This error is not caused by Symantec
reading drive X, Abort,
Ghost. It is caused by malfunctioning hardware or software
Retry, Fail
configurations. The image file on the CD is not readable. To verify
this, go into DOS and copy the image file off of the CD-ROM using
copy verification, copy /v.
Some errors may occur that do not produce an error code.
"Command-line switches"
Table E-3
on page 175.
on page 132.
Advertisement
Table of Contents
