Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual page 109

5 Add other switches to the command line to execute specific command-line
options on the client computer, if required.
For example, if the initial command is:
-clone,mode=pcreate,src=2,dst=@mcSessionNm
Add the following switches to avoid prompts and restart the client computer
after the image has been extracted:
-clone,mode=pcreate,src=2,dst=@mcSessionNm -sure -rb
Only use the -sure switch when you are certain that you are writing from the
intended disk or partition.
6 Click Accept Clients to accept the client computer into the session.
7
Start the client computers in DOS.
8
Run Ghost.exe using the -ja switch to log on to the GhostCast session from
the command line:
ghost.exe -ja=SessionNm
9 Confirm your choices on the client computers if the -sure switch was not
used.
See "Running Ghost.exe on a client computer"
To restore an image onto client computers using the GhostCast Server
1
Create a GhostCast session to restore an image from the GhostCast Server.
2 Click More Options.
3 In the Disk No. box, type the disk number.
Using GhostCasting to create and restore images
Controlling the GhostCast session from the server
on page 115.
109