Specifying The Sensitivity Level For Paper Protection [Paper Protection Sensitivity] - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings
Specifying the Sensitivity Level for Paper
Protection [Paper Protection Sensitivity]
You can specify the level of sensitivity to detect anomalies
upon feeding the documents when paper protection is
enabled.
Documents are deformed (e.g. warped, bent, creased) when
they are not being fed by the rollers properly. To detect such a
symptom and stop the scan, select [Low] to only detect
documents that are highly deformed, and [High] to also detect
documents that are slightly deformed.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Paper Protection Sensitivity].
3
Specify the sensitivity level.
Low : Decreases the sensitivity level to detect warped
documents.
Normal : Monitors the documents in normal sensitivity.
Keep this setting for normal use.
High : Increases the sensitivity level to detect warped
documents.
If paper jams occur frequently, specify [Low].
153).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
178